冲裁速度对冲压件断面质量的影响赵中华.pdfVIP

17 4 塑性工程学报 Vol17 No4 2010 8 JOURNAL OF PLAST ICITY ENGINEERING Aug 2010 doi: 103 6 / jissn1007- 201220100400 * ( 1 上海工程技术大学 材料工程学院, 上海 201620) 1, 2 1 2 赵中华 张 猛 韦习成 ( 2 上海大学 材料学院, 上海 201620) : , , Cockcroft-Lat ham , , H1F60CS , 20% , , , , , , : ; ; ; ; + : T G3863 5 : A : 1007-2012 (2010) 04-0045-05 Study of influence of blanking velocity on section quality of stamping work-piece 1, 2 1 2 ZH AO Zhong-hua ZH ANG Meng WEI Xi-cheng ( 1College of Material Engineering, Shanghai University of Engineering Science, Shanghai 201620 China) (2College of Material, Shanghai University , Shanghai 201620 China) Abstract: Suitably physical and FEM models w ere set up and the Cockcroft Latham rule and suitable f racture factor w ere select- ed. Based on the H1F60CS servo press machine adopted, several different stamping velocit ies w ere designed. The results of FEM simulation and physical experiments show that the best section quality could be gained when stamping velocit y is set to 20% of general speed, which is consistent t o real experience that lower velocity is good to improving section quality . But when st am- ping velocity is further slow down, the height of burr increases and the height of burnish zone decreases, w hich means the section qualit y depresses contrarily. Key words: blanking; real blanking velocity ; section quality; fracture rule; fracture factor [ 1] , ,