单相SPWM逆变器并联解耦控制策略.docVIP

英文资料原文来源:JOURNAL OF ELECTRONIC SCIENCE AND TECHNOLOGY OF CHINA,VOL.7,NO.3, SEPTEMBER 2009 Decoupling Control Strategy for Single Phase SPWM Parallel Inverters Shun-Gang Xu,Jian-Ping Xu,and Tai-Qiang Cao Abstract: A decoupling control strategy of inverter parallel system is proposed based on the equivalent output impedance of single phase voltage source SPWM (sinusoidal pulse width modulation) inverter. The active power and reactive power are calculated in terms of output voltage and current of the inverter, and sent to the other inverters in the parallel system via controller area network(CAN)bus. By calculating and decoupling the circumfluence of the active power and reactive power, the inverters can share load current via the regulation of the reference-signal phase and amplitude. Experimental results of an 110V/2kVA inverter parallel system show the feasibility of the decoupling control strategy. Index Terms-CAN bus, current sharing, inverters, parallel operation. 1. Introduction Parallel operation of inverters is an efficient way to enhance the capacity and reliability of inverter systems. The key issue of parallel operation is the distribution of the load current. In an inverter parallel system, the amplitudes and phases of output voltages of all inverters should strictly equal to each other to guarantee that each inverter shares the same load current. Otherwise, the current circumfluence and overload of some inverters in the inverter parallel system may exist. The current circumfluence may also decrease the efficiency and reliability of the inverter parallel system. There are various techniques for the control of inverter parallel operation. Among these techniques, central control and master-slave control are easy to implement and have good current-sharing performance. However, these two control strategies work at the cost of system reliability because of conjunction operation among inverters. In instantaneous-current control of inverter parallel system, there