ASTMD7332纤维增强复合材料紧固件的抗过拉阻力测试标准.pdfVIP

Designation: D7332/D7332M – 09 Standard Test Method for Measuring the Fastener Pull-Through Resistance of a Fiber-Reinforced Polymer Matrix Composite1 This standard is issued under the fixed designation D7332/D7332M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. 1. Scope responsibility of the user of this standard to establish appro- 1.1 This test method determines the fastener pull-through priate safety and health practices and determine the applica- resistance of multidirectional polymer matrix composites rein- bility of regulatory limitations prior to use. forced by high-modulus fibers. Fastener pull-through resis- 2. Referenced Documents tance is characterized by the force-versus-displacement re- 2 2.1 ASTM Standards: sponse exhibited when a mechanical fastener is pulled through a composite plate, with the force applied perpendicular to the D792 Test Methods for Density and Specific Gravity (Rela- plane of the plate. The composite material forms are limited to tive Density) of Plastics by Displacement continuous-fiber or discontinuous-fiber (tape or fabric, or both) D883 Terminology Relating to Plastics reinforced composites for which the laminate is symmetric and D3171 Test Methods for Constituent Cont