Research on the effect of boundary pressure on the boundary heat transfer coefficients between hot stamping die and boron steel》.pdf

International Journal of Heat and Mass Transfer 91 (2015) 401–415 Contents lists available at ScienceDirect International Journal of Heat and Mass Transfer journal homepage: www.else /locate/ijhmt Research on the effect of boundary pressure on the boundary heat transfer coefficients between hot stamping die and boron steel Li Huiping ⇑, He Lianfang, Zhang Chunzhi, Cui Hongzhi School of Materials Science and Engineering, Shandong University of Science and Technology, Qingdao, Shandong 266590, PR China a r t i c l e i n f o a b s t r a c t Article history: Boundary heat transfer coefficient (BHTC) between the hot stamping die and boron steel is one of the Received 30 September 2014 most important thermal physical parameters in the hot stamping. A software of inverse heat conduction Received in revised form 14 May 2015 problem (IHTP) was developed based on the optimization method and finite element method. NiCr–NiSi Accepted 23 July 2015 thermocouples were used to measure the temperature of sample, and the high speed data collection Available online 11 August 2015 device was used to acquisite the electrical signal from the thermocouples. The BHTC between hot stamp- ing die and boron steel was calculated by the IHTP software according to the temperature curve. Main Keywords: factors affecting the evaluation accuracy of BHTC were discussed, such as surface temperature of test Boundary heat tra