SS400含硼钢连铸坯的高温力学性能.pdfVIP

第50 卷 第 7 期 钢 铁 Vol.50，No.7，p38-42 2 0 1 5 年 7 月 Iron and Steel July 2015 DOI ：10.13228/j.boyuan.issn0449-749x SS400 含硼钢连铸坯的高温力学性能 王 炜， 周律敏， 熊 力， 薛正良 （武汉科技大学钢铁冶金及资源利用省部共建教育部重点实验室，湖北 武汉 430081 ） 摘 要：为了避免和减轻SS400 含硼钢连铸坯表面裂纹，采用Gleeble- 1500热模拟试验机对SS400 含硼钢连铸坯的 高温力学性能进行了测试，获得其在650～1350 ℃范围内热延塑性和高温强度的特性。试验结果表明，SS400 含硼 钢连铸坯的高温强度较低，且其高温强度随温度的升高而下降。SS400 含硼钢的塑性区间仅在1 000～1 100 ℃温度 范围内，该温度范围内试样的断面收缩率均大于90% ；SS400 含硼钢的低塑性区间较宽，第Ⅲ脆性温度区间为700～ 950 ℃，主要原因是硼在晶界的偏聚以及BN 等第二相粒子在晶界析出后脆化晶界；局部区域的重熔也降低了SS400 含硼钢在1 150～1 250 ℃温度区间内的塑性。 关键词：含硼钢；高温强度；热延塑性；断面收缩率；连铸 文献标志码：A 文章编号：0449-749X （2015 ）07-0038-05 High temperature mechanical property of SS400 B-bearing steel slab WANG Wei ， ZHOU Lü-min ，XIONG Li ，XUE Zheng-liang （Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education ，Wuhan University of Science and Technology ，Wuhan 430081 ，Hubei ，China ） Abstract ：In order to avoid and reduce surface cracks of SS400 B-bearing steel slab ，the high temperature mechanical properties of SS400 B-bearing steel slab have been investigated in the temperature range of 650- 1 350 ℃by the hot ten- sile test technique with Gleeble- 1500 system. The results showed that its yield strength and tensile strength in the tempera- ture range were relatively small ；in general，which decreased with increased tested temperature. Only in the range of 1000- 1 100 ℃，SS400 B-bearing steel slab has good hot ductility and the reductions of area were higher than 90%. The third brittle zone of the SS400 B-bearing steel is between 700-950 ℃. The low plasticity temperature range i