《经形变热处理铜基形状记忆合金的晶粒生长、形状记忆和腐蚀行为(英文期刊)》.pdfVIP

Trans. Nonferrous Met. Soc. China 23(2013) 2896−2904 Kinetic grain growth, shape memory and corrosion behavior of two Cu-based shape memory alloys after thermomechanical treatment Ahmad Ostovari MOGHADDAM, Mostafa KETABCHI, Reza BAHRAMI Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran Received 13 September 2012; accepted 13 December 2012 Abstract: Metallurgical and mechanical properties along with shape memory and corrosion behavior of Cu−11.8% Al−3.7% Ni− 1%Mn and Cu−11% Al−5.6% Mn shape memory alloys (SMAs) were comparatively studied. The influence of grain refinement on the properties was studied by optical microscopy (OM), scanning electron microscopy (SEM), differential scanning calorimetry (DSC), potentiodynamic polarizations and bend and tensile tests. Static recrystallization and kinetic grain growth show a rapid recrystallization in the first 15 s of annealing at 800 °C followed by grain growths. The minimum grain sizes obtained after 15 s are 90 and 260 μm for Cu−Al−Ni−Mn and Cu−Al−Mn, respectively. Tensile tests show typical three-stage curves for both alloys, and it is seen that alloys exhibit high fracture stress and strain after grain refinement. Microstructural observations show zig-zag morphology of β′ martensite in the Cu−Al−Ni−Mn and coexistence of β′ and γ′ in the Cu−Al−Mn, which were confirmed by 1 1 1 differential scanning calorimetry results. The shape memory ratios (η) of the alloys before thermomechanical treatment, and after thermomechanical annealing at 800 °C for different time up to 15 min followed by water