Ⅱ级人员实际考试及评分记录.docVIP

ASME ＲＴ EVALUATION RECORD OF PRACTICAL EXAMINATION PAPER FOR LEVEL Ⅱ PERSONNEL 射线探伤Ⅱ级人员实际考试评分记录 NO. 编号 EXAMINEE 姓名 DATE 日期 EXAMINER 主考 SCORE 得分 NO. 序号 Content And Requirement 内 容 与 要 求 Percent 比例(%) Grade 得 分 1 Whether the preparation of equipment, tools and material for radiographic examination is sufficient? 射线照相设备,工具,材料准备是否适当? 10 2 Whether the radiographic arrangement and geometric condition are correct? 透照布置和几何条件是否正确? 10 3 Whether the placment of all the markers conforms with the requirement? 是否按照规范要求布置标记? 10 4 Whether IQI and placement selection is correct? 像质计的选用和放置是否正确? 10 5 Whether the mask of scatter radiation is sufficient? 散射线屏蔽是否充分? 5 6 Whether the selection of exposure condition (kVp, mA·min) is acceptable? 曝光条件的选择是否适当? 10 7 Whether the film is processed properly? (e.g. Temperature, time, agitation etc.) 底片处理是否适当? （如温度、时间、搅动等） 10 8 Whether the image quality of radiograph conforms with the specified requirements? （e.g. Density, IQI sensitivity, without blemishes, etc.） 底片影像质量是否符合规定要求? (如黑度、像质计灵敏度、无污迹等) 10 9 Whether the interpretation of the radiographic result is correct? 透照结果的评定是否正确? 15 10 Whether the testing record and report is complete and correct? 检验记录 、报告是否完整、正确? 10 ASME ＵＴ EVALUATION RECORD OF PRACTICAL EXAMINATION FOR LEVEL Ⅱ PERSONNEL 超声波Ⅱ级人员实际考试评分记录 NO. 编号 EXAMINEE 姓名 DATE 日期 EXAMINER 主考 SCORE 得分 NO. 序号 Check points考试内容 Requirements要求 Proportion 比例(%) Grade 得分 1 Preparation of operation procedure card 编制操作工艺卡(10%) Completeness完整性 Correctness正确性 5 5 2 Instrument calibration 仪器校验(5%) Adjusting Zero point零点校正 Adjusting time base时基调整 2 3 3 Test block试块 (5%) Selection and use of the block试块的选用 5 4 Search unit探头 (5%) Selection of the search unit探头的选用 5 5 Operation practice检验 (25%) Preparation探伤准备 5 Drawing and using DAC curve (E. M Lines) 绘制和使用距离-波幅校正曲线 10 Selection of inspect surface and side 探伤面、侧的选择 10 6 Scanning Method扫查方法 (5%) Scanning sensitivity 扫查灵敏度 Scanning transverse flaw 扫查