毕业论文：基于单片机的身高体重测量仪.docVIP

课程设计说明书 Kechengshejishuomingshu 地 市： 准考证号： 姓 名： 李奥华 河南省高等教育自学考试 基于单片机的身高体重测量仪 摘　　要 本文了一基于单片机设计利用电源电路、单片机最小系统电路、、独立按键电路、电路可以，基本满足设计要求。关键词：STC89C52；超声波；；Height and weight measurement instrument based on MCU ABSTRACT This paper introduces a height and weight measurement instrument based on MCU , The design use a MCU as the platform, using metal strain gauges to induction of the weight of the human body. Because the ultrasonic propagation velocity is fixed, so according to the propagation time to calculate the propagation distance, so as to get the height information. Through the serial port MCU can communicate with the PC. The hardware circuit includes power circuit, MCU minimum system circuit, LCD circuit, serial communication circuit, independent key circuit, a buzzer circuit, ultrasonic module circuit, AD converter circuit and a full bridge circuit. The software includes the main program, the system initialization program, AD converter communication program, button detection program, the ultrasonic signal emitting and receiving procedures, LCD driver program. This design can simultaneously measure the body height and weight, and can also send data to the host computer display or derived form document and save. Height and weight measurement instrument based on MCU of low cost, simple circuit design, clear display, basically meet the design requirements. Key words：STC89C52Ultrasonic；HX711；Host computer 目　　录 1　绪论 1 2　身高体重测量仪总体方案设计 2 2.1　设计方案的选定 2 2.2　身高体重测量仪的工作过程 3 3　身高体重测量仪的硬件电路设计 4 3.1　电源电路 4 3.2　单片机最小系统电路 4 3.3　串口通信电路 5 3.4　超声波模块接口电路 6 3.5　独立按键电路 6 3.6　液晶屏电路 7 3.7　蜂鸣器电路 8 3.8　HX711 AD转换器模块接口电路 8 3.9　全桥电路 9 3.10　总体硬件电路及其工作原理 10 4　软件设计 11 4.1　主函数的编写 11 4.2　系统初始化函数的编写 13 4.3　HX711 AD转换器通信函数的编写 13 4.4　按键检测函数的编写 14 4.5　超声波模块函数的编写 16 4.6　液晶屏驱动函数的编写 17 5　开发平台及调试 19 5.1　硬件的制作 19 5.2　硬件的开发平台 20 5.3　软件的调试 20 5.4　软件的开发平台 21 5.5　上位机软件 22 6　总结 23 6.1　特点 23 6.2　不足与改进 23 参考文献 24 致谢 25 附录１ 26