IntroductiontoEngineeringandTechnologyConcepts.pptVIP

Introduction to Engineering and Technology Concepts Unit Seven Chapter One – Machine Tools Instructions for Success: Each chapter of every unit will begin with a “Mindjog.” This is a warm up question that you should answer in your workbook in the proper chapter. Please take notes as you move through the presentations in the notebook that has been provided. Sections will come up in each presentation with an assignment notice. Turn to the section detailed on the slide in your workbook and complete the assignment before proceeding. Good luck! Objective Students will define types of machine tools, especially those found in the technology education laboratory. Mindjog! On your worksheet, please respond to the following question:? “What kind of tools do you use to accomplish everyday tasks? Think about this question by recalling the simple machines we have previously discussed.” Processing Before we get started, realize that tools and machines are used in three major types of processing: Material Processing Energy Processing Information Processing For the purposes of this Unit, we will be looking at tools and machines used in material processing (Wright, 2004). Machine Tools All specialists would be lost without their tools of trade. Imagine a dentist without a dental drill or bricklayer without a tape measure! It is the same in engineering and technology. Without the proper tools, tasks cannot be accomplished correctly. Within this unit, we are going to discuss some common machine tools that are used in the field and the safety precautions behind them (Wright, 2004). Machining It has already been stated that machines are artifacts that amplify the speed, amount, or direction of a force. They transmit or change the application of power, force, or motion. Specifically, machine tools are machines that are used to make other machines. Machining is a separating process based on the motion of a tool against a work piece (Wright, 2004). Characteristics Machine too