Single-phaseseriesa.c.circuits.pptVIP

Single-phase series a.c. circuits Purely resistive a.c. circuit In a purely resistive a.c. circuit, the current IR and applied voltage VR are in phase. See Figure 1. Figure 1 Purely inductive a.c. circuit In a purely inductive a.c. circuit, the current IL lags the applied voltage VL by 90? (i.e. π/2 rads). See Figure 2 Figure 2 In a purely inductive circuit the opposition to the flow of alternating current is called the inductive reactance, XL where : f is the supply frequency, in hertz, L is the inductance, in henrys. Purely capacitive a.c. circuit In a purely capacitive a.c. circuit, the current IC leads the applied voltage VC by 90? (i.e. π/2 rads). See Figure below. In a purely capacitive circuit the opposition to the flow of alternating current is called the capacitive reactance, XC where C is the capacitance in farads. R–L series a.c. circuit In an a.c. circuit containing inductance L and resistance R, the applied voltage V is the phasor sum of VR and VL (see Figure), and thus the current I lags the applied voltage V by an angle lying between 0? and 90? (depending on the values of VR and VL), shown as angle φ. In any a.c. series circuit the current is common to each component and is thus taken as the reference phasor. From the phasor diagram of Figure 15.6, the ‘voltage triangle’ is derived. For the R–L circuit: R–L series a.c. circuit (continued) In an a.c. circuit, the ratio applied voltage V divided by current I is called the impedance Z, i.e. If each side of the voltage triangle in Figure 15.6 is divided by current I then the ‘impedance triangle’ is derived. R–C series a.c. circuit In an a.c. series circuit containing capacitance C and resistance R, the applied voltage V is the phasor sum of VR and VC (see Figure 15.10) and thus the current I leads the applied voltage V by an angle lying between 0? and 90? (depending on the values of VR and VC), shown