模具专业英语 王浩钢 14456第17章新.pptVIP

Lesson 17  Castings Shaw investment casting 　　The manufacture of cavities and cores in steel by the conventional casting method using sand moulds is not satisfactory owing to the poor finish obtained and to the porosity which occurs on, or just below, the surface of the casting.① 　　The expenditure involved in plugging, machining and finishing uneconomic. 　　The Shaw investment casting process does not, however, share the disadvantages associated with sand casting and is therefore applicable to specialists and the mouldmaker supplies the company with a pattern of the required mould part.②