CONTRIBUTIONSTOMANAGEMENTSWARFHIGH-SPEEDMACHINETOOLS.docVIP

CONTRIBUTIONS TO MANAGEMENT SWARF HIGH-SPEED MACHINE TOOLS Baila Diana University Politehnica of Bucarest, Splaiul Independentei 313, Bucharest, Romania baila_d@ Abstract: The transition from traditional manufacturing with machine tools and CNC machine tools at high speeds requires modification on the technological concept of steel, machinery, tools and cutting regimes. This paper aims to draw attention to changes in management and management swarf. It also presents some additional tests designed to increase the life of tools used at high speeds. Key words: traditional machine tools, CNC machine tools and high speed, conical swarf, semi swarf, SIM analysis. INTRODUCTION Development of manufacturing with high-speed machine tools previously claimed, the development of techno-economic study further the research and management chip. In general, chip generation and management problems have made ??practical activities in workshops, which resulted in finding technical solutions and safety, as correct. In this respect, with the evolution of machine tools have diversified and expanded research objectives, as follows: -the traditional machine tools (lathes, milling machines) with cutting speeds of 35-70 m/min was used Merchant model to calculate the optimum cutting conditions and chip evacuation recommendations were included in the STAS: -chip-shape and characteristics; -how to remove the chip from the workpiece; -compression chip-evacuation and transportation are provided by the factory. -the NC machine tools and CNC machining centers at speeds of 60-120 m / min was used Oxley model [7], [10] to calculate the optimum cutting conditions and chip evacuation is included in STAS. -the high-speed machine tools 150-480 m /min, is used at present, the american way [1] to calculate rough cutting regimes. Household chips are discharged inside the car and involves the following elements: -detached from the workpiece chips should have taper type IIIB; -to remove chips fr