CE6302MechanicsofSolids-DMICollegeofEngineering.docVIP

DMI COLLEGE OF ENGINEERING, DEPARTMENT OF CIVIL ENGINEERING CE6302 MECHANICS OF SOLIDS II YEAR/ III SEMESTER UNIT I STRESS AND STRAIN PART – A Define stress and Strain. State Hooke’s Law. Define Factor of Safety. Define Tensile Stress and Tensile Strain. Define Shear Stress and Shear Strain. Define Volumetric Strain. Define Modulus Of Elasticity. Define Modulus of Rigidity. State Bulk Modulus. State Poisson’s ratio. State the relationship between Young’s Modulus and Modulus of Rigidity. State the relationship between Bulk Modulus and Young’s Modulus. Define Compound Bar. State the types of Elastic constants. Write the relations used to find the forces in compound bars made of two Materials subjected to tension. Define strain energy density. Determine the Poisson’s ratio and Bulk modulus of a material for which Young’s modulus is 1.2 x 105 N/mm2 and Modulus of rigidity is 4.8 x 104N/mm2. Give the relation for change in length of a bar hanging freely under its own weight. A Brass rod 2m long is fixed at both its ends. If the thermal stress is not to exceed 76.5N/mm2, calculate the temperature through which the rod should be heated. Take the values of α and E as 17 x 10-6/K and 90GPa respectively. Define Resilience. PART B 1. (i). A mild steel rod 2m long 3cm diameter is subjected to an axial pull of 10KN. If E for steel is 2 x 105 N/mm2, find (a). Stress, (b) Strain, (c). Elongation of the rod. (ii). A cast iron column has internal diameter of 200mm. What should be the minimum external diameter so that it may carry a load of 1.6 MN and safe stress is 90N/mm2. 2. A steel bar 900mm long. Its two ends are 40mm and 30mm in diameter and the length of each rod is 200mm. The middle portion of the bar is 15mm in diameter and 500mm long. If the bar is subjected an axial tensile load of 15KN, determine , (i) Stresss in each section (ii)Total Extension 3. An axial pull of 40KN is acting on a bar consisting of three sections of length 300mm, 250mm and 200mm and of diamet