High-temperaturecarburizationbehaviourofHASTELLOYX.PDFVIP

Title in CH4 gas Author(s) CitationCorrosion Science, 53(10): 3131-3138 Issue Date2011-10 DOI Doc URL /2115/47204 Right Type article (author version) Additional Information File CS53-10_3131-3138.pdf Information Instructions for use High-temperature Carburization behaviour of HASTELLOY X in CH gas 4 a a b b a Chihiro Matsukawa , Shigenari Hayashi , Hiroshi Yakuwa , Tadahiko Kishikawa , Toshio Narita , Shigeharu Ukaia aFaculty of Engineering, Hokkaido University, Sapporo, Japan bEBARA Corporation, Japan Abstract * Ni-base wrought alloy HASTELLOY X tube was exposed to Ar-CH at 800 and 1000 ˚C in order 4 to understand the carburization kinetics of the alloy used for fuel injection nozzles of micro-gas turbine combustors. Three different internal carbides, (Cr,Mo) C , (Cr,Mo) C and (Cr,Mo) C were observed in 3 2 7 3 23 6 this order from the surface, and the partial damage to the outer surface of the specimen tube appeared similar to metal-dusting. The internal carburization kinetics on both the inner and outer parts of tube followed the parabolic rate law. The carbon permeability in HASTELLOY X was obtained, and was slightly smaller than that of Ni-20%Cr. Key words High-temperature corrosion, Carburization, Ni-base alloy, Metal dusting, carbon diffusion Footnote *: Hatelloy is the registered trademark of Haynes International, Inc. 1. Introduction