CuttingandPatching-TheCaliforniaStateUniversity.docVIP

Section 01045 - Cutting and Patching (To Be Included Only When Applicable) Part 1 - General 1.01 Related Documents A. Contract General Conditions. B. (TO BE PROVIDED BY THE ARCHITECT) 1.02 Summary A. This Section specifies administrative and procedural requirements for cutting and patching. B. Work included in this Section 1. Cutting and patching not required to be performed as part of the work of other sections. 2. Cutting and patching existing work altered or disturbed to accommodate new construction. 3. Cutting and patching existing work damaged or defaced during new construction as required to restore to existing or better condition at the time of award of Contract. 4. Cutting and patching required to: a. Install or correct non-coordinated work. b. Remove and replace defective and non-conforming work. c. Remove samples of installed work for testing. C. Refer to other Sections and drawings for specific requirements of the extent and limitations applicable to cutting and patching, demolishing, or altering existing work of individual parts of the Work. Requirements of this Section also apply to mechanical and electrical installations. (Refer to Division15 and Division16 Sections for other requirements and limitations applicable to cutting and patching mechanical and electrical installations). 1.03 Submittals A. Cutting and Patching Proposal: Where approval of procedures for cutting and patching is required before proceeding, submit a proposal describing procedures well in advance of the time cutting and patching will be performed and request approval to proceed. Include the following information, as applicable, in the proposal: 1. Describe the extent of cutting and patching required and how it is to be performed. 2. Describe anticipated results in terms of changes to existing construction; include changes to structural elements and operating components as well as changes in the building’s appearance and other significant visual elements. 3. List produ