1RevisionLog.docVIP

1 Revision Log 2 2 Responsibilities 2 3 Modifications to procedure 2 4 Tool box 3 5 Commissioning check list valve type: 01-6471-01/02/0300 4 6 Typical Handover Certificate 9 7 Cleaning of filters 10 7.1 Pressure regulator 10 7.2 Solenoid valve 10 8 Testing cylinder valve opening 11 8.1 Diverter valve system 11 8.1.1 Preparation 11 8.1.2 Verify 11 8.1.3 After verification. 11 8.2 Single area system 12 8.2.1 Preparation 12 8.2.2 Verify 12 8.2.3 After verification. 12 9 CE marking acct. pressure directive, PED: 13 9.1 Distribution piping downstream the restrictor 13 9.1.1 Category I Module A 13 9.1.2 Category II Module A1 14 10 Alternative pilot line test 15 10.1 Description of unit 15 10.2 Unit in use 16  Revision Log Revision Page, Section Description Date 0 All For Comments 2000.05.01 1 All For project use 2000.06.01 2 6,7,8, Updated 2000-11-07 3 24 Torque increased 2001.06.10 4 4, 8, 9 Acceptable pressures stated in step 1.EC declaration information. Alt. test and Control unit added 2002-08-10 5 Responsibilities It is the responsibility of the Design engineer in charge of a specific Argonite installation to ensure that the requirements listed herein are incorporated in the project documentation and that detailed information’s/procedures are made available to the commissioning engineer. Modifications to procedure Should the user at any point have comments or the like which could improve or clarify the content it would be appreciated if these comments are informed to the issuer Ginge-Kerr Danmark A/S on Fax. +45 36 77 22 31. Commissioning Procedures – Argonite system After completion of installation, the Argonite system should be commissioned by a Ginge-Kerr Commissioning engineer or a Ginge-Kerr certified Commissioning engineer. The enclosed Commissioning Checklist should as a minimum be followed in order to ensure the continued availability, safety and optimal efficiency of the system. In the period after the commissioning and hand over, it is re