CylinderHazmatTraining.pptVIP

Fill as slow as possible Never exceed 600 psig per minute for air, 200 psig per minute for nitrox or 60 psig per minute for oxygen * PSI-PCI, Inc. 2014 All Rights Reserved Do NOT use fill whips or any connecting components above their rated service pressure Fill whips and connectors require maintenance * PSI-PCI, Inc. 2014 All Rights Reserved Bleeder valves under pressure are extremely dangerous, use caution Bleeder valves require maintenance, replace as necessary * PSI-PCI, Inc. 2014 All Rights Reserved Bullet points provide ample explanation on slides 36 - 39 * PSI-PCI, Inc. 2014 All Rights Reserved Fill tubs or containers become part of the fragmentation, especially when water is used * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved It is imperative to blow out valves and fill whips prior to connecting to prevent introduction of contaminates to cylinder * PSI-PCI, Inc. 2014 All Rights Reserved FSO is responsible for judgment call on cylinder condition for filling A cylinder is “acceptable”, “rejectable” or “condemnable” * PSI-PCI, Inc. 2014 All Rights Reserved Check with local and state laws * PSI-PCI, Inc. 2014 All Rights Reserved A respirator by definition is the entire unit: valve, mask, cylinder, pack or any associated equipment * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved Cylinders used for “quick filling” or “emergency filling” should be like new or in pristine condition * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved Setting a cylinder aside (“reject”), refusing to fill is the decision of the FSO * PSI-PCI, Inc. 2014 All Rights Reserved As is * PSI-PCI, Inc. 2014 All Rights Reserved PSI-PCI, Inc. 2014 All Rights Reserved * PSI-PCI, Inc. 2014 All Rights Reserved * As is * PSI-PCI, Inc. 2014 A