HalfSectionHalfSection-transport@itu.edu.tr.PDFVIP

Half Section • A half-section is a view of an object showing one-half of the view in section. Half Section • Symmetrical parts can be shown in half sections. • Half section without hidden lines 1 Half Section • Half sections are commonly used to show both the internal and outside view of symmetrical objects. Half Section 2 Offset Section • The cutting plane is off-set to include features that are not in a straight line. • Figure on the right is a example of offset section. Offset Section • It is possible for the cutting plane to change directions, to minimise on the number of sectional views required to capture the necessary detail. • The example below shows a pipe being cut by two parallel planes. The sketch shows where the object is cut. 3 Offset Section Broken out Section • A small portion of an object needs to be sectioned to expose internal details. • Part or broken out sections can be used. Command : SKETCH 4 Broken out Section • It is common practice to section a part of an object when only small areas need to be sectioned to indicate the important details. The example above shows a part sectional view to indicate a through-hole in a plate. Notice that the line indicating the end of the section is a thin continuous line. Revolved Section • Revolved sections are useful when clarifying local cross- section shapes as shown in Figure.