Installation,OperationRepairPartsInformationMODEL.PDFVIP

Installation, Operation MODEL G300 Repair Parts Brake Bleeder Information Branick Industries, Inc. 4245 Main Avenue P.O. Box 1937 Fargo, North Dakota 58103 Rev013107 P/N: 81-0035C CAUTION Before using this product, read and fully understand the operating instructions and all decals on the product. This is necessary to prevent injury to the operator and damage to the product. Refer to vehicle service manual for proper bleeding procedure. Do not use Aviation or Hydraulic Fluid with this product. Product Damage May Result. Avoid allowing Brake Fluid to contact vehicle finished surfaces. Damage to the surface finish may result. Always wear appropriate eye protection. NOTE: THE G300 BRAKE BLEEDER WILL CEASE TO OPERATE WHEN ALL OF THE BRAKE FLUID IS EXPELLED AND THE DIAPHRAGM IS AT THE TOP OF THE TANK. THE DIAPHRAGM MUST BE PUSHED DOWN TO THE BOTTOM OF THE TANK BEFORE THE BLEEDER WILL OPERATE AGAIN. When the G300 BRAKE BLEEDER is empty of brake fluid, slowly release the air pressure using the air valve at the bottom of the tank. Remove the air valve when all of the air has been released. The internal rubber diaphragm will be inverted inside the tank and must be gently pushed back into place using a blunt instrument. The Bleeder can now be refilled with brake fluid and the air valve can be replaced. Before operating the G300 Brake Bleeder, install the handle assembly to the Brake Bleeder. OPERATION___________