NicktaneDuramaxFuelFilterInstallInstructions.pdf.PDFVIP

Nicktane Duramax Fuel Filter Install Instructions Revision 071503 Thank you for purchasing the Nicktane Duramax Fuel Filter Kit. Please read all the directions thoroughly before beginning the installation process. Kit Contents: 1 Filter bracket, black w/ holes pre-drilled 1 Filter Base - CAT 1 Fuel Filter - Tall 1 Fuel Filter - Short 1 Cover - Priming Pump 1 Gasket - Priming Pump Cover 1 Bolt - Priming Pump Cover 1 Washer - Priming Pump Cover Bolt 1 Bolt - Priming Pump Cover 1 Washer - Priming Pump Cover Bolt 1 Bolt - Bleeder 1 O-Ring - Bleeder Bolt 1 Hose - 1/2 ID 12 2 Clamp - Hose 2 Fitting - 90 Parker -6 SAE to JIC -10 2 Fitting - Pushlock for 1/2 ID Hose 3 Cable Guards 6 Bolt Emigh - Stainless Steel 6 Nut - Nylon Lock, Stainless Steel 6 Washer - Lock, Stainless Steel 12 Washer - Stainless Steel 1) Mount Filter Head to Bracket: Tighten the 2 bolts fastening the priming cover plate to the filter head, as well as the larger bleeder bolt. Install the filter head to the filter bracket using 2 stainless steel bolts, 4 washers, 2 lock washers, and 2 lock nuts as shown in the picture below. 2) Mount Filter Bracket to Truck: Position the bracket underneath the truck, inside the driver’s-side rear fender well. Make sure to prevent the bracket from catching on the filler next when you position it in place. Next, take a 7/32” drill bill and drill through the holes in the bracket and into the under-bed rail. One hole should already exist in your bed. Simply line up that one and the filter head, then drill the remaining 3. Next use the remaining 4 stainless steel bolts, 8 washers, 4 lock wash