- 1、本文档共54页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
摘 要
电子负载的原理是控制内功率MOSFET或晶体管的导通量靠功率管的耗散功率消耗电能的设备负控制环路控制环路电路的核心实质在这里既作为电流的控制器件同时也作为被测电源的负载。从而达到电子负载的恒流控制ABSTRACT
The principle of electronic load is control of transistors inside power MOSFET or the guide flux of power tube, it is a consumption power equipment which depends on the dissipation power of tube, there are four basic working ways that persistence pressure, constant current, the constant resistance, constant power .
This design start with the analysis of DC electric load system solutions, it discussed the realization of the whole system hardware circuit and software in detail, and give a reasonable solution. In order to realize the control and the expansion of function conveniently, we adopted the STC89C52 microcontroller as the core controller, and designed the DA output control circuit, AD voltage current detection circuit, keyboard circuit, display circuit and drive circuit, through the coordination between hardware and software, finally, we realized the whole design. PI adjuster and negative feedback control loop of the circuit which control the grid voltage of MOSFET, so as to change its resistance. The core essences are the op-amp, MOS tube here both as a control device and as a power load tested. Controlling the guide flux of the MOS tube, the resistance of the MOS tube will change accordingly, thus the current which flows the electronic load current will constant, At last, we realized constant current work pattern.
This design can realize the Constant-current control of the electronic load: it can measured the current, voltage and power of Measured power and the LCD display. If it use situations in rated, no matter how the input voltage change in the constant-current mode (within a certain range), the electronic load will be based on setting to absorb the current, the current which flows the electronic load will constant.
Key words: electronic load; constant-current pattern; PI adjuster; AD transform; DA conversion
目 录
绪 论 1
第一章 电子负载系统设计方案 2
您可能关注的文档
- 2016_【高级精品】2015年基于单片机的步进电机控制器的设计论文3929263.doc
- 2016_【高级精品】2015年基于单片机的点阵.doc
- 2016_【高级精品】2015年基于单片机的电机转速测量系统设计(答辩版)完整毕业设.doc
- 2016_【高级精品】2015年基于单片机的电子琴论文.doc
- 2016_【高级精品】2015年基于单片机的电子时钟的设计-毕业论文.doc
- 2016_【高级精品】2015年基于单片机的电子钟设计毕业论文.doc
- 2016_【高级精品】2015年基于单片机的电阻、电容、电感测试仪.doc
- 2016_【高级精品】2015年基于单片机的火灾报警系统.doc
- 2016_【高级精品】2015年基于单片机的简易电子琴设计.doc
- 2016_【高级精品】2015年基于单片机的简易数字电压表的设计.doc
文档评论(0)