DefectCausesAnalysisfortheReinforcedConcreteSiloFormedonSlipformingConstruction.PDFVIP

Hans Journal of Civil Engineering 土木工程, 2013, 2, 259-265 /10.12677/hjce.2013.25044 Published Online November 2013 (/journal/hjce.html) Defect Causes Analysis for the Reinforced Concrete Silo Formed on Slipforming Construction Li Pan Institute of Building Structures, China Academy of Building Research, Beijing Email: Panli535482@, Panlicabr@163.com Received: Aug. 15th th rd , 2013; revised: Sep. 14 , 2013; accepted: Sep. 23 , 2013 Copyright © 2013 Li Pan. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Abstract: For the slipforming construction to built reinforced concrete silos, it is not only faster and easier relatively than that in usual, but also less template investment and it brings about continuous operation. The method is still widely used to built this kind of tall and regular cross-section concrete shells, such as chimneys, cooling towers, radio and TV towers etc. and it is token as special sets of construction technology at home and abroad for many years. In recent years, a number of engineering surveys in the domestic showed that the following shell defects appeared easily in slipforming construction and affected them badly, such as surface concrete strength was less generally than that of the internal and the design requirement, poor concrete adhesive around reinforcements, more irregular and annular cracks on silo walls. To resolve these problems, careful analysis and research are done for the quality deterioration of reinforced concrete silos due to slipforming techniques, and then some improved sugges