溷凝土工业地坪设计施工方案-超平地坪concrete_industrial_ground_floors_tr34-2003_部分5.pdfVIP

PART TWO : SURFACE REQUIREMENTS CHECKLIST Check S or N/A Section Reference Abrasion resistance Section 5.2 Chemical resistance Section 5.3 Colour and appearance Section 5.4 Slip resistance Section 5.9 Steel fibre visibility at the surface Section 5.11 Joint types, layout and spacing Chapter 8 Special requirements : Flatness Chapter 4 and Appendix C PART THREE : GENERAL Floor to be loaded days after construction Operating temperature/range Environmental considerations (e.g. ground conditions , gas venting) Other © The Concrete Society, Technical Report 34, 2003 91 APPENDIX B WORKED EXAMPLE: THICKNESS DESIGN OF A GROUND-SUPPORTED FLOOR SLAB Bl INTRODUCTION B2 DESIGN DATA This worked example illustrates how the procedures in Materials : Chapters 7 to 9 can be applied to a steel-fibre-reinforced f cu 40 N/mm2 ground-supported slab subjected to a number of loading f ck 32 N/mm2 arrangements typically found