四层电梯控制系设计毕业论文.docVIP

郑 重 声 明 本人呈交的学位论文，是在导师的指导下，独立进行研究工作所取得的成果，所有数据、图片资料真实可靠。尽我所知，除文中已经注明引用的内容外，本学位论文的研究成果不包含他人享有著作权的内容。对本论文所涉及的研究工作做出贡献的其他个人和集体，均已在文中以明确的方式标明。本学位论文的知识产权归属于培养单位。 本人签名： 日期： 摘 要 电梯在国民经济和生活中有着广泛的应用电梯成为重要的运输设备之一。国内传统的电梯控制是由继电器、接触器构成。它不仅存在着可靠性差、成本高、故障率高等缺点,而且在层数增加时,配线变化给制造及安装带来诸多不。PLC实现对电梯电气系统的控制，大大的提高了系统控制的优越性，降低了成本，减小电气控制系统的的故障率。 该课题的设计任务利用可编程控制器（PLC）分析FX2N型PLC电梯的整个程序设计的过程,并主要阐述了三个方面控制要求、系统配置、软件设计。：PLC；控制系统ABSTRACT Elevator is widely applied in the national economy and life. The elevator has become one of the important transport equipment. Traditional domestic elevator control is composed of a relay, contactor. It is not only the existence of poor reliability, high cost, high failure rate and shortcomings, but also in layers increases, changes to the wiring and installation of manufacturing has brought a lot of inconvenience. To achieve control of the elevator electrical system with PLC. Greatly improve the superiority of system control, reduce cost, reduce the fault rate of electric control system. The subject of design tasks using the programmable controller (PLC) for electrical control freight elevator, the subject of design thinking is the logic control principle, according to the transport rule control requirements and its own elevator, in response to random external call signal. Through the design analysis, selection of Mitsubishi FX2N type PLC electric control system offreight elevators throughout the design process, and mainly discusses three aspects: the requirements of the control system, configuration, system software design. The core control part of the use of the software program control, in order to ensure the normal operation of the elevator, the requirements of the situation, greatly improve the elevator fault inspection and repair convenience and easy, but also overcomes some brought by manual operation of human disturbance factors, the expected results had a good effect . Key words：elevator ;PLC ;control system ; de