PROPINTERFACE(N)资料.ppt

INTERFACING Copyright ? Eaton Hydraulics 2000 Steve Skinner, Eaton Hydraulics, Havant, UK 典型安装 24V DC 一个典型的比例阀安装可能由阀(A),放大板(B),电源 ?和输入信号装置 (D). 对于每个元件安装都需要仔细考虑。 A B C D Max Min Nominal Maximum Ripple OUTPUT VOLTAGE 电源 24 V (20 V) (34 V) (4 V) The nominal voltage supply for the amplifier will normally be 24 V DC although 12 V options are available in some cases. The voltage tolerance is quite wide, typically from 20 volts minimum to 34 volts maximum. The minimum voltage must be maintained under full load conditions. Where the DC voltage is derived from an AC supply, there may be some residual ripple effect on the DC level but this must not exceed typically 4 volts. Max Min OUTPUT VOLTAGE POWER SUPPLY 24 V (20 V) (34 V) 注意必须确保任何电压波动不能低于最小的电压限制。 Care must also be taken to ensure that any voltage ripple does not dip below the specified minimum voltage level. 控制 任何输入线路上的电干扰将放大并使阀的操作漂移。 Any electrical noise on the input connection to the amplifier will be amplified and may cause erratic operation of the valve. EUROCARD INSTALLATION Where the amplifier is mounted in a rack inside a shielded electrical cabinet and where the proportional valve is not fitted with spool feedback sensors then the installation is relatively well protected from electrical noise. EUROCARD INSTALLATION Where the amplifier is mounted in a rack inside a shielded electrical cabinet and where the proportional valve is not fitted with spool feedback sensors then the installation is relatively well protected from electrical noise. EUROCARD INSTALLATION Where the amplifier is mounted in a rack inside a shielded electrical cabinet and where the proportional valve is not fitted with spool feedback sensors then the installation is relatively well protected from electrical noise. EUROCARD INSTALLATION Where the amplifier is mounted in a rack inside a shielded electrical cabinet and where the proportional valve is not fitted with spool feedback sensors then the installation is relatively well protected from