a reynolds stress model for turbulent flow of homogeneous polymer solutions：均匀聚合物溶液湍流流动的雷诺兹应力模型.pdfVIP

International Journal of Heat and Fluid Flow 54 (2015) 220–235 Contents lists available at ScienceDirect International Journal of Heat and Fluid Flow journal homepage: /locate/ijhff A Reynolds stress model for turbulent flow of homogeneous polymer solutions M. Masoudian a,⇑, K. Kim b, F.T. Pinho a, R. Sureshkumar c a Transport Phenomena Research Center, Faculty of Engineering, University of Porto, Rua Dr. Roberto Frias s/n, 4200-465 Porto, Portugal b Department of Mechanical Engineering, Hanbat National University, 125 Dongseo-daero, Yuseong-gu, Daejeon 305-701, South Korea c Department of Biomedical and Chemical Engineering, Department of Physics, Syracuse University, NY 13244, USA a r t i c l e i n f o a b s t r a c t Article history: Using a priori analyses of direct numerical simulation (DNS) data, a Reynolds stress model (RSM) is Received 24 October 2014 developed to account for the influence of polymer additives on turbulent flow over a wide range of flow Received in revised form 10 April 2015 conditions. The Finitely Extensible Nonlinear Elastic-Peterlin (FENE-P) rheological constitutive model is Accepted 27 May 2015 utilized to evaluate the polymer contribution to the stress tensor. Thirteen DNS data sets are used to ana- Available online 18 June 2015 lyze the budgets of elastic stress–velocity gradient correlations as well as Reynolds stress and dissipation transport. Closures are developed in the framework of the RSM model for all the required unknown an