基于软化拉-压杆模型方法的钢筋混凝土变梁中节点抗剪承载力研究.pdfVIP

第 27 卷第 9 期 Vol.27 No.9 工 程 力 学 2010 年 9 月 Sep. 2010 ENGINEERING MECHANICS 201 文章编号：1000-4750(2010)09-0201-08 基于软化拉-压杆模型方法的 钢筋混凝土变梁中节点抗剪承载力研究 * 吴 涛， 邢国华，刘伯权，黄 华 (长安大学建筑工程学院，陕西，西安 710061) 摘 要：根据 10 个梁高不等钢筋混凝土框架中节点试件在低周反复荷载作用下的试验结果，重点分析了该类框 架节点的破坏过程和破坏特点。在试验研究的基础上，建立了框架中节点等效核心区在剪、压复合作用下的计算 模型，应用软化拉-压杆模型方法(简称 SSTM)对等效核心区进行了受力分析。研究表明：软化拉-压杆模型理论计 算值与试验结果接近，与现行规范建议方法计算结果相当，但软化拉-压杆模型方法有明确的力学计算模型，能较 为合理地反映框架节点的受力机理。 关键词：变梁；中节点；计算模型；软化拉-压杆模型；简化计算方法 中图分类号：TU375.4 文献标识码：A SHEAR STRENGTH OF RC FRAME JOINTS CONNECTING BEAMS WITH DIFFERENT DEPTHS USING SOFTENED STRUT-AND-TIE MODEL * WU Tao , XING Guo-hua , LIU Bo-quan , HUANG Hua (School of Civil Engineering, Chang’an University, Xi’an 710061, China) Abstract: Ten interior joint specimens of beams with different depths were tested under reversed cyclic loading. The failure characteristics and failure processes of interior joints were analyzed. Based on the experimental study, an analytical model for the equivalent joint core of the frame joint under the combined actions of axial and shear loads was established, and the shear strength of the equivalent joint core of tested specimens was calculated by using softened strut and tie model(SSTM). Results showed good agreement in the shear strength of the joint between the SSTM results and the experimental results, and these results are close to those of the code method. The SSTM has a clear mechanical model and can reasonable reveal the failure mechanism of beam-column joint. Key words: beams with different depths; interior joint; calculation model; softened strut-