单片机自动增益放大器资料.docVIP

自动增益放大器 摘 要：本系统有四个模块组成：程控放大器，峰值检测，液晶。程控放大器采用两片AD603接连组成，放大电压增益可达50dB，增益0.2v步进可调，电压增益误差不大于5%。放大器输出无明显失真。峰值测量采用真有效值采样芯片AD637先进行有效值采样，然后通过PCF8951进行AD采样，最后再转换成峰值，液晶采用LCD1602，系统以stc89c51单片机为控制核心，经测试验证，系统运行稳定，操作方便。 关键词： 程控放大器，峰值检测，AD采样，单片机。 Abstract：This system has three modules: SPC amplifiers, peak detection, liquid crystal. By two AD603 program-controlled amplifier amplification voltage gain one, can gain 1db stepping 0.2v, adjustable, voltage gain error is not more than 5%. Amplifier output without obvious distortion. Measure true RMS peak by sampling AD637 chip on sampling, then PCF