某热油管道扩能技术研究方案论文.docVIP

重庆科技学院 毕业设计（论文） 题 目 学 院 石油与天然气工程学院 专业班级 学生姓名 学号 指导教师 职称 评阅教师 职称 2012年月日封面（按教务处制定的标准封面格式制作）中文摘要（300字左右）、关键词 外文摘要、关键词 目次页（附件不统一编入） 论文主体部分：引言（或绪论）、正文、结论参考文献附录（对论文支持必要时）100万吨/年，管道最高压力7.0MPa，现原油年输量达到150万吨。根据管线情况和工程实际经验分析，该设计通过对增加泵站数、加减阻剂、增加泵数、更换泵的方案进行管线的热力水力计算，判定各个站及管段在不同方案中的参数，判定四种方案的可行性。对方案分析后预选取了增加泵数、更换泵、加减阻剂的方案进行计算校核。确定该管线扩能研究方案是采取在乌图美仁站增加泵组改为热泵站来增加泵站数的方案完成，确定管线的运行参数完成管线扩能方案。 关键词：泵 减阻剂 管线 摩阻损失  ABSTRACT In process of oil field development technology due to the improvement of production equipment updates are promoted oil field production increases, so the pipeline expansion study is necessary. Pipeline, an oil field oil pipeline, with an open process, all eight stations, three pump stations, four stations, and a terminal station, the largest annual output1000000 tons / year, a maximum pressure of7.0MPa pipeline crude oil, the annual throughput reached 1500000 tons. According to the pipeline and practical analysis, the design through to increase pumping station number, adding drag reducer, increase the number of pump, pump replacement scheme of pipeline thermal and hydraulic calculation, judging whether each station and the pipe section in the different parameters in the schemes, decide four scheme feasibility. Analysis on scheme of pre-selecting the number increased after the pump, pump replacement, adding drag reducer for calculation. Determination of the pipeline on the capacity expansion of solution is taken in the United States increased pump group changed to kernel station pump station to increase pumping station number scheme, determine the pipeline operation parameters to complete the line capacity expansion plan. 翻译结果重试 抱歉，系统响应超时，请稍后再试 支持中英、中日在线互译 支持网页翻译，在输入框输入网页地址即可 提供一键清空、复制功能、支持双语对照查看，使您体验更加流畅 Keywords：pumprag reduction agent；pipeline；friction loss  目 录 摘 要 I ABSTRACT II 1绪 论 1 1.1课题研究目的、意义 1 1.2热油管线扩能技术研究国