新rav车身电气详解.pptVIP

* * * * 左侧室外后视镜盲区监视传感器：主 左侧室外后视镜盲区监视传感器：副 [检查 DTC] 连接 诊断仪 / GTS 和 DLC3. 发动机开关打开 (IG ON). 打开盲点监测主开关. 打开 诊断仪 / GTS . 进入菜单: Body Electrical Blind spot monitor Master or Blind spot monitor Slave Trouble Codes. 检查 DTC [C1ABB/C1ABC] 更换盲点监测传感器后这些故障码一直保存 更换盲点监测传感器之后完成光轴检查以避免输出这些故障码 * [C1AC1/C1AC2] These DTCs are stored when the angle of the blind spot monitor sensor deviates more than the allowable range from the horizontal axis. If the drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch on, the blind spot monitor system may store these DTCs by mistake. [C1AC1/C1AC2] 当室外后视镜盲区监视传感器水平轴方向偏离角度超出允许值范围时存储故障码。 在室外后视镜盲区监视主开关打开时，如果使用如车速试验台，制动/车速组合仪或底盘测功机 等滚筒测试仪时，系统会错误的存储故障码。 * * * * * * * * * * The lane departure alert system is equipped for -A [TMMC Production], -K, -W and -_. Basic structure and operation are a same as ES350/250 (ASV, GSV60). 道路偏离警告系统在 -A [TMMC 车型], -K, -W and -_配备。 基本结构和操作与ES350/250 (ASV, GSV60)相同。 * * * * Basic structure and operation are a same as CAMRY (ASV, GSV50). 基本结构和操作与凯美瑞 (ASV, GSV50)相同。 * [Before Replacement] The transmitter IDs registered in the door control and tire pressure warning system receiver is read by using the Techstream / GTS. If reading the stored transmitter IDs is impossible due to malfunctions of components such as the door control and tire pressure warning system receiver, remove the tires from the wheels and check the IDs located on the tire pressure warning valve and transmitters. [After Replacement] The read transmitter IDs is registered in a new door control and tire pressure warning system receiver by using the Techstream / GTS. [更换前] 使用诊断仪/GTS读取注册在门控和胎压警告系统接收器里的发射器ID。 因门控和胎压警告系统接收器组件故障无法读取发射器ID，从车轮上拆下轮胎，检查发射器ID。 [更换后] 用诊断仪 / GTS将读取注册在新的门控和胎压警告系统接收器里的发射器ID。. * Certification ECU Certification ECU is installed at the right side of the air conditioning unit. 认证 ECU 认证ECU安装在空调单元右侧 * * Back door automatic opening operation stop