m基于ATC的密码锁().docVIP

//rs----PD4//rw----PD5//en----PD6//data---PORTB//SDA---PC1//SCL---PC0//beep--PA6//开锁---PB7//开锁状态----PB5//如果把uchar const initpassword[6]={0,0,0,0,0,0};改为_flash uchar initpassword[6]={0,0,0,0,0,0};//则出现这错误found `unsigned expecting `;可我没找到错误在哪？？？#include iom16v.h#includemacros.h#include stdio.h#include stdlib.h#include string.h#define uchar unsigned char #define uint unsigned int#define w 6 //定义密码位数uchar operation=0; //操作标志位uchar pass=0; //密码正确标志uchar ReInputEn=0; //重置输入充许标志 uchar s3_keydown=0; //3秒按键标志位uchar key_disable=0; //锁定键盘标志uchar countt0,second; //t1中断计数器,秒计数器//void Delay5Ms(void);uchar InputData[6]; //输入密码暂存区uchar CurrentPassword[6]={1,3,1,4,2,0}; //当前密码值uchar TempPassword[6];uchar N=0; //密码输入位数记数uchar ErrorCont; //错误次数计数uchar CorrectCont; //正确输入计数uchar ReInputCont; //重新输入计数#pragma data:codeuchar const a[]={0xFE,0xFD,0xFB,0xF7}; //控盘扫描控制表uchar const start_line[] = {password: };uchar const name[] = {===Coded Lock===}; //显示名称 uchar const Correct[] = { correct }; //输入正确 uchar const Error[] = { error }; //输入错误uchar const codepass[] = { pass }; uchar const LockOpen[] = { open }; //OPENuchar const SetNew[] = {SetNewWordEnable};uchar const Input[] = {input: }; //INPUTuchar const ResetOK[] = {ResetPasswordOK };uchar const initword[] = {Init password...};uchar const Er_try[] = {error,try again!};uchar const again[] = {input again };uchar const initpassword[6]={0,0,0,0,0,0};/***************************************************************************************************/void port_init(){ DDRA|=BIT(6); PORTA|=BIT(6); DDRB=0xFF; PORTB=0xFF; DDRC=0xFF; PORTC=0xFF;}/***********************************************************************************************/void segg()//关数码显示管函数 { DDRA|=BIT(PA3); //PA3设置为输出状态 DDRA|=BIT(PA4); //PA4设置为输出状态 DDRB=0xff; //PB口设置为输出状态 PORTB=0xf