技术参数中英对照(部分)资料.docVIP

序号serial number?项??????????????? 目Project?数值Value1?发电机型式Generator model?立轴、悬式、三相、凸极、同步发电机Vertical shaft, suspended type, 3-phase, salient pole, synchronous generator2?额定值Rated value??额定容量(MVA)Rated capacity?205?最大有功功率(MW)(cosФ=1.0)Maximum active power?205?额定电压(kV)Rated voltage?13.8?额定电流(A) Rated current ?8576.6?额定频率(Hz) Rated frequency?60?额定功率因数Rated power factor?0.9（滞后lagging）?额定转速(r/min) Rated speed?300?飞逸转速(r/min) Runaway speed?530?飞轮力矩(t.m2) Flywheel torque?66003?额定电压、额定转速和额定容量下的损耗The loss under rated voltage, rated speed and rated capacity??-功率因数为0.9时 When the power factor is 0.9??定子绕组铜损(kW) The copper loss of stator winding ?387（75°C）?转子绕组铜损(kW) The copper loss of rotor winding?336（75°C）?铁芯损耗(kW) Iron loss ?365?风损耗和摩擦损耗(kW) Windage loss and friction loss? ?1085?导轴承损耗(kW)Guide bearing loss ?117?推力轴承损耗(kW) Thrust beading loss ?143?杂散损耗(kW)（包括励磁系统损耗）Stray loss (including the excitation system loss)?297?总损耗(kW) Total losses?2730?-功率因数为1.0时When the power factor is 0.1??定子绕组铜损(kW) The copper loss of stator winding?387（75°C）?转子绕组铜损(kW) The copper loss of rotor winding?215（75°C）?铁芯损耗(kW) Iron loss?365?风损耗和摩擦损耗(kW) Windage loss and friction loss?1085?导轴承损耗(kW) Guide bearing loss?117?推力轴承损耗(kW) Thrust bearing loss?143?杂散损耗(kW) （包括励磁系统损耗）Stray loss (including the excitation system loss)?292?总损耗(kW) Total losses ?26044?电气参数 Electrical specifications??定子每相电阻(75℃, Ω) Each phase resistance of stator ?0.001752?转子电阻(75℃, Ω) Rotor resistance ?0.0882?负序电阻(75℃, Ω)Negative sequence resistance?0.002954?零序电阻(75℃, Ω)Zero sequence resistance?0.005119?三相对地电容(μF) Three-phase ground capacitor?3.3235?电磁负荷Electromagnetic load ??气隙磁密(T) Air-gap Flux density ?0.787?定子齿部磁密(T) stator -tooth flux density ?1.599?定子轭部磁密(T) Stator- yoke flux density ?1.085?定子电流密度(J, A/mm2)Stator current density?3.05?定子线负荷(As, A/cm) Stator linear load ?747?转子电流密度(J, A/mm2) Rotor current density ?2.35?空载励磁电流(Ifo，A) no-load excitation current ?1093?空载励磁电压(Ufo, V) n