路由器双端口测试管理器研究与开发 本科生毕业（设计）论文.docVIP

西 南 交 通 大 学 研 究 生 学 位 论 文 路由器双端口测试管理器研究与开发 Classified Index: TP393 Southwest Jiaotong University Master Degree Thesis RESEARCH and develop on TWO-PORT TEST SYSTEM UNDER ROUTER Distributed Multi-port Synchronized Parallel TEST July 2005摘 要 本论文的研究背景是路由器测试技术。多端口、高速性和既支持IPv6又支持IPv4是从IPv4向IPv6过渡的整个历史时期的特点。以ISO9646为代表的传统的路由器测试方法为单端口的“回绕测试法”（LTM）和双端口的“穿越测试法”（TTM），难以适应现代路由器多端口的特点；高速路由器的性能测试要求测试方法的高效性和端口间的同步协调，在LTM和TTM中都缺少相应的支持。所有这些就是四川省网络通信重点实验室（SC-Netcom Lab）（MSP-TTM）“多端口路由器分布式并发测试系统”（MPR-DCTS）开发的路由器分布式多端口并发测试系统为两层结构：上层为路由器多端口测试管理器（RMPTM – Router Multi-Port Test Manager），下层路由器双端口测试器（RTPT – Router Two-Port Tes））（MDSP-TTM））IPv6 are characterized by multi-ports, high-speed, and complication in supporting both IPv4 and IPv6. The orthodox test methods defined in ISO 9646, i.e. LTM (Loop-back Test Method) and TTM (Transverse Test Method) are not catered for such router testing. Performance testing for high-speed routers demands high-efficiency in testing as well as synchronization among multi-ports. All these have spurred the research activities at Sichuan Network Communication Key Laboratory (SC-Netcom Lab), which are represented by the novel test method called DMSP-TTM (Distributed Multi-port Synchronized Parallel – TTM) and development of MPR-DCTS (Multi-Port Router – Distributed Concurrent Test System). The distributed multi-port concurrent test system under development at SC-Netcom Lab takes a two-layer structure: the upper layer formed of the Router Multi-Port Test Manager (RMPTM) and the lower layer composed of multiple “Router Two-Port Testers (RTPT)”. RTPTM deals with multi-port test issues such as RTPT configuration, test case distribution, and synchronization among multiple RTPTs. RTPT on the other hand, supports both LTM and TTM and acts either as an independent test device or the low-layer device of the MPR-DCTS. The work presented in this dissertation is focused on techniques relevant to RTPTM (Router Two-Port Test Manager). The roles of an RTPTM