应用于10Gbs光接收机的全差分CMOS跨阻前置电路设计.pdfVIP

第44卷第5期 红外与激光工程 2015年5月 Vol.44No.5 InfraredandLaserEngineering May2015 应用于 10Gb/s 光接收机的全差分CMOS跨阻前置电路设计 王 巍，武 逶，冯 其，颜琳淑，王 川，王冠宇，袁 军，王 振 (重庆邮电大学 光电工程学院，重庆 400065) 摘 要院设计了一种的低成本、低功耗的10Gb/s光接收机全差跨阻前置放大电路。该电路由跨阻放 大器、限幅放大器和输出缓冲电路组成，其可将微弱的光电流信号转换为摆幅为400mVpp 的差分电 压信号。该全差分前置放大电路采用0.18滋m CMOS工艺进行设计，当光电二极管电容为250fF 时， 该光接收机前置放大电路的跨阻增益为92dB赘，-3dB 带宽为7.9GHz，平均等效输入噪声电流谱密 度约为23pA/(0~8GHz)。该电路采用电源电压为1.8V 时，跨阻放大器功耗为28mW，限幅放大器功 耗为80mW，输出缓冲器功耗为40mW，其芯片面积为800滋m伊1700滋m。 关键词院光接收机； CMOS前置放大电路； 跨阻放大器； 限幅放大器 中图分类号院TN46 文献标志码院A 文章编号院1007-2276(2015)05-1587-06 Design of a fully differential CMOS transimpedance preamplifier for 10Gb/s optical receiver Wang Wei, Wu Wei, Feng Qi, Yan Linshu, Wang Chuan, Wang Guanyu, Yuan Jun, Wang Zhen (College of Electronics Engineering, Chongqing University of Posts and Telecommunications, Chongqing 400065, China) Abstract: A low cost and low power consumption optical receiver differential transimpedance preamplifier for 10Gb/s high-speed optical communications application was presented. The preamplifier includes a tranimpedance amplifier (TIA), limiting amplifier (LA), and output buffer, the weak photo鄄current was amplified by the preamplifier to a differential voltage swing of 400mVpp. The preamplifier was designed in 0.18滋m CMOS technology. The receiver preamplifier circuit is with a transimpedance gain of up to 92dB赘 and -3dB bandwidth of 7.9GHz, which accommodates a photodiode capacitor of 250fF. The noise simulation result shows that the average input鄄referred noise current spectral density is 23pA/up to 8 GHz. The power dissipation of transimpedance amplifier, limiting amplifier and output buffer respectively drain is 28mW, 80mW, and 40mW fro