数字化称重仪表-大学生毕业论文（设计）.doc

毕业设计论文 数字化称重仪表 摘 要 关键词：STC89C52单片机；A/D转换；LED显示 Digital Weighing Instrument Abstract As a result of the early digital circuits and analog technology, the lower level of development, the complex structure and cumbersome operation,weighing instruments have been unable to meet current market requirements for the weighing system.The features of weighing, weighing speed and weighing accuracy for the rapid development of digital weighing industry have been lagging behind. Digital Weighing Instruments are developed on the basis of analogue weighing instrument. Today, as a result of limitated usness of micro-computers and embedded systems in the weighing field, so that weighing instrument does not achieve its demands in the aspects of integration and digital. Therefore, in order to meet todays market requirements of the weighing technology, the design with micro-computer and weighing technology is a kind of new multi-functional digital load meter. It not only has features of setting system parameters, automatically clearing, data processing, fault self-diagnosising,automatically correctting errors,etc,but also gets simple structure, small size, low cost,on-site adaptability, weighing accuracy,high reliability and good dynamic response. In this paper, in-depth on the design of digital weighing instrument on the basis of the methods, a new type of digital weighing instrument of the overall program design is completed primarily; hardware control system flow chart is completed; the arm and so the whole resistance strain sensor bridge circuits, the three op amp instrumentation amplifier circuit and A/D conversion circuit system data sampling circuit are completed; the system of control procedures, system design software program initialization,parameter settings, A/D conversion and failure alarm processing software module design is completed. Key words: resistance strain sensor; Single-chip STC89C52; A/D conversion; LED display 目 录 摘 要 I Abstract II 第一章 绪论 1 1.1 课题研究背景与意义 1