流水线上的产品的分检与检测 大学毕业论文.docVIP

镇 江 高 专 ZHENJIANG COLLEGE 课 程 设 计 (论文) 流水线上的产品的分检与检测 (Products on the assembly line and test sorting) 摘 要 本系统是对四节传送带控制的系统，该设备适用于流水线生产等，也可以把生产的货物进行传递到特定的地方。高可靠性是电气控制设备的关键性能。PLC由于采用现代大规模集成电路技术，采用严格的生产工艺制造，内部电路采取了先进的抗干扰技术，和同等规模的继电接触器系统相比，电气接线及开关接点已减少到数百甚至千分之一，故障也大大降低。此外，PLC带有硬件故障自我检测功能，出现故障时可及时发出警报信息，在应用软件中，应用者还可以编入外围器件的故障自我判断程序，使系统中除PLC以外的电路及设备也获得故障自我判断保护。 关键词：plc，柔性生产线，分检系统,检测系统 Abstract This system is a system which controls to four conveyer belts this equipment is suitable for the production-runs and so on also may the cargo which produces carry on transmits to the specific place. The redundant reliability is the electricity control device essential performance .PLC because uses the modern large scale integrated circuit technology used the strict production craft manufacture the internal circuit has adopted the advanced amazing technology had the very high reliability Machine the external circuit said from PLC that , uses the PLC constitution control system , compares with the same level scale relay system , the electrical wiring and the switch contact reduced to several hundred even several 1/1,000, the breakdown also greatly reduces , In addition , PLC has the hardware , the application also may enroll the periphery component the breakdown from the diagnostic program , causes in the system also obtains the breakdown besides the PLC electric circuit and equipment from the diagnosis protection Key Word: plc ,the flexible production line, categorizing system，test sorting 目 录 第一章 绪论 ·········································4 第二章 系统的总体方案································5 第三章 硬件系统······································6 3.1硬件接线图··································6 3.2硬件图······································6 3.3模块I/O说明································7 第四章 软件系统······································8 4.1 顺控图······································10 4.2 梯形图······································12 第五章 软件调试······································16 总结··········