基于单片机的稳压电源设计(world)要点.doc

本科毕业设计（论文） 题目 基于单片机的稳压电源设计 学 院 电气与自动化工程学院 年 级 专 业 班 级 学 号 学生姓名 指导教师 职 称 论文提交日期 2015-05-25 常熟理工学院本科毕业设计(论文论文 基于稳压电源设计 Intelligent Power Design Based on MCU Abstract Power technology is a very practical, widely used in all walks of engineering, teaching often requires the use of experimental power supply for the circuit to provide energy. In the rapid development of power electronics technology today, we voltage stability and accuracy have put forward higher requirements. This paper presents the hardware design and software-based intelligent power supply STC12C5A60S2 simulation debugging, to make up for the shortcomings of traditional regulated power supply. The design of the transformer module, rectifier module, three-terminal voltage regulator module, LCD1602 LCD module, independent of the keyboard module, digital to analog conversion module, the voltage with the amplifier module and power amplifier module. Voltage range of DC voltage 0V-12V, continuously adjustable in steps of ?.1V and ?.01V. Regulators value of the system by keyboard input control voltage values established by the LCD1602 LCD display, good design a circuit stability, strong anti-jamming capability, ideal for general research in the field of teaching. Key Words: Intelligent Power; MCU; Numerical Control; Continuously adjustable stepper 目 录 1. 绪 论 1 1.1 课题研究的背景和意义 1 1.2 现今发展状况 1 1.3 研究方法及内容 2 2. 系统设计原理 3 2.1 设计要求 3 2.2 系统设计框图 3 3. 系统硬件设计 5 3.1 系统供电电源设计 5 3.2 STC12C5A60S2主控模块 6 3.3 数模转换电路设计 6 3.4 显示模块 8 3.4.1液晶显示屏简介 8 3.4.2 LCD引脚定义 9 3.5 功率放大电路设计 11 3.6 辅助电路设计 11 4. 系统软件编程设计 12 4.1 系统总体设计流程图 12 4.2按键控制流程 12 4.3 液晶显示流程 14 4.4 DA驱动和线性化调整 15 5. 系统的调试与分析 16 5.1 系统的软件调试 16 5.2 系统的硬件调试 17 5.3 实验结果的分析 19 论文小结 20 参考文献 21 附录 22 致谢 31 1. 绪 论 1.1 课题研究的背景和意义 随着现代科学技术的发展，人们对电子产品的需求也不仅仅局限于某