控制行波管工作的浮动板调制器的设计与制造 毕业论文.docVIP

控制行波管工作的浮动板调制器的设计与制造 第一章 方案的选择 摘 要 本设计的主要内容就是设计一个用于控制行波管工作的浮动板调制器。说明书首先对雷达发射机做了一个大概的介绍，然后对包含我设计任务的行波管发射机的内部组成一一作了介绍，对本设计要制作的浮动板调制器在行波管发射机中的作用也进行了说明，然后对线形调制器和刚性调制器的工作原理以及区别优劣作了比较，对为什么要采用浮动板调制器作了说明，同时对浮动板调制器的电路组成，工作原理作了详细介绍，由于要制作成实物印制板，所以对组成浮动板调制器的印制板的绘制，元器件封装的选择与更改，相关集成库的建立，都作了详细介绍，浮动板调制器是行波管发射机内部的关键器件，它只有与其它器件一起才能工作，所以说明书对行波管发射机内部和浮动板调制器密切相关的其他部分也作了相关简要介绍。 关键词 行波管 浮动板调制器 印制电路板 行波管发射机 Abstract This design primary coverage is designs one to use in controlling the TWT work the floating plate modulator,The instruction booklet first has made a general introduction to the radar transmitter,Then to contained me to design the duty the TWT transmitter interior to compose content has made the introduction，The floating plate modulator must manufacture which to this design was an expert to good expert in the TWT transmitter the function also to carry on the explanation，Then has made the comparison to the linear modulator and the rigid modulator principle of work as well as the difference fit and unfit quality,Why to had to use the floating plate modulator to give the explanation。Meanwhile to the floating plate modulator electric circuit composition, the principle of work has made the detailed introduction,Because must manufacture the board in kind, therefore to composes the floating plate modulator the PCB, The choice and the change seals which to the primary device, the correlation integrates the storehouse the establishment, all has made the detailed introduction.The floating plate modulator is the TWT transmitter interior essential component, it only then can work together with other components, therefore the instruction booklet with has also made a synopsis to the TW tube transmitter interior other components with the fluctuation board modulator relations。 Keywords: TWT floating plate modulator Printed circuit board TWTtransmitter 目 录 前言 第一章 方案的选择 一 采用行波管作发射机的放大器的原因