塑胶电镀重点分析.ppt

塑膠電鍍介紹 Plating on Plastics * * 塑膠電鍍介紹 Plating on Plastics 塑膠電鍍原理及注意事項Principles of Plating on Plastic 第一站 素材選擇 ABS塑料案例 (Step 1:Selecting Material ABS Plastic Case) 1.最好採用電鍍級ABS塑膠如圖所示其丁二烯含量15%~16%密著強度最好 Selects the ABS plastics showing on the right which the butadiene is 15%-16%.Its adhesion is best. 2.采用70%~95%PC+ABS材料要請供應商提供防火材料%、PC%、等相關資料 Applier should offer fireproof material, PC%,etc,and references before selecting 70%-95%PC+ABS. 3.塑膠電鍍原料應完全乾燥(含水率0.1%以下) Materials of plating on plastic should be dried totally. 4.塑膠電鍍原料盡量避免染色Materials of plating on plastic must prevent dyein