【参考】基于UG的标准斜齿圆柱齿轮及变位齿轮的参数化建模.docVIP

基于UG的标准斜齿圆柱齿轮及变位齿轮的参数化建模 所 在 学 院 机械工程学院 专 业 名 称 机械设计制造及其自动化 年 级 二零一零级 学生姓名、学号 指导教师姓名、职称 讲师 完 成 日 期 年月 效率ABSTRACT Gear is the machinery industry is widely applied in one of the parts, and gear of gear tooth accurate three-dimensional modeling is regarded as dynamic simulation, NC gear machinery processing, the interference of the finite element analysis test and the foundation. But in UG7.0 software and no special module, so in this paper expounds in UG7.0 platform is established on the helical gear shift gears and three dimensional model of the new method. Because the outline of the helical gear line is not standard curve, want to realize the precise gear modelling modeling has the certain difficulty. The helical gear commonly used the shaping method is sweeping ChengXingFa, but this method of modeling is not accurate. In order to change this weakness, this paper puts forward through the establishment of the involute tooth root, transition curve equation of symmetry, accurate boundary calculated with curve starting, termination number Angle, the free form the sweeping characteristics for the tool solutions. This method accord with standard helical gear tooth profile line of the definition, can realize the precise modeling gear. Through the example modeling, this method is also applicable to shift gears of parameterized modeling, improve the gear shift of the project design efficiency Key words: The helical gear and shift gears; Involute; Transition curve; Symmetrical equation; Parameterized modeling  目录 1 引言 1 1.1国内外的研究现状及发展趋势 1 1.2课题研究内容 2 1.3课题研究的意义 2 1.4参数化建模策略 3 1.5 Unigraphics介绍 4 2斜齿轮的基本参数与几何尺寸计算 5 2.1斜齿轮基本参数 5 2.2设置齿轮参数和相关尺寸计算 5 2.2.1前、后端面齿廓曲线的生成 6 2.2.2齿根过渡曲线的建立 8 3 标准斜齿圆柱齿轮的参数化建模 11 3.1 基圆直径小于齿根圆直径即Z分界齿数时 11 3.1.1设置斜齿轮基本参数 11 3.1.2斜齿轮计算参数的设置 11 3.1.3创建斜齿轮前、后端面齿廓 12 3.1.