利用PROFIBUSDP现场总线掌上智能家居设计开发总结.doc

利用PROFIBUS-DP现场总线掌上智能家居设计开发 【摘要】：当今工业迅速发展，工业复杂化程度日益增高，在工业控制过程中，工程软件需要进行大量的现场信号采集，并且，数据的传递与转换以及对系统的控制精度、可靠性都密切影响着系统的数据采集信息，因此，工程师们研发了新型的现场总线控制系统FCS。现场总线种类繁多，PROFIBUS因为其性能优异，所以在工业控制系统中被广泛应用，因此我们要设计一个智能节点，以微控制器为核心，能够使现场控制器与底层传感器和执行器进行双向通信，来完成4-20mA模拟信号到串行信号的转换、节点地址的设定、检测数据的显示，数据交换过程的指示，超限警报以及UART到PROFIBUS总线的转换这些任务。本论文主要内容包括利用PROFIBUS-DP现场总线掌上智能家居设计开发的设计方案；SPC3芯片的使用；系统软硬件设计。 【关键词】：PROFIBUS-DP现场总线，智能家居设计开发的设计方案，SPC3芯片，系统软硬件设计。 Abstract：Fast development of industry, rising industrial sophistication in the process of industrial control, engineering software needs a large number of field signal acquisition, and data transfer and conversion as well as the control precision and the reliability of the system are closely affecting the information system of data collection, as a result, engineers have developed a new type of fieldbus control system FCS. There are many different kinds of fieldbus, PROFIBUS because of its excellent performance, so is widely used in industrial control system, so we had to design an intelligent node, microcontroller as the core, can make the controller a two-way communication with the underlying sensors and actuators, to complete the 4-20 ma analog signal to a serial signal conversion, the nodes address set, test data show that the data exchange process instructions, transfinite alarm and UART to PROFIBUS bus convert these tasks. This thesis main contents including the use of handheld profibus-dp fieldbus intelligent household design scheme of design and development; The use of SPC3 chip; System software and hardware design. Key words：Profibus-dp field bus, the design scheme of intelligent household design and development, SPC3 chip, system hardware and software design. 目录 前言................................................... PROFIBUS-DP现场总线及其通信协议简介........... §1.1 便携式血压计简介................................ §1.2 血压计装置设计方案............................. 智能从站专用通信接口芯片SPC3................. §2.1 血压计装置设计方案........................ §2.2.......................