LTE中基于S1的切换.docVIP

LTE中基于S1的切换 HYPERLINK /showpic.html \l blogid=673b30dd0100je8burl=/orignal/673b30ddt8962fe203ab3 \t _blank 1：源eNodeB决定进行基于S1的切换。S1切换的原因可能是源eNodeB和目标eNodeB之间不存在X2连接，或者源eNodeB根据其他情况作出的判断。 2：源eNodeB向源MME发送Handover Required消息，主要包括如下一些内容： IE/Group Name Presence Message Type M MME UE S1AP ID M eNB UE S1AP ID M Handover Type M Cause M Target ID M Direct Forwarding Path Availability O SRVCC HO Indication O Source to Target Transparent Container M 其中Handover Type在此时是intra-LTE，TargetID包含Target Cell ID和Target TAI两部分（目标TAI信息是从哪里获得的？），源MME可以根据目标 TAI来选定合适的目标MME。 Direct Forwarding Path Avaliability用来指示在源和eNodeB之间是否存在存在直接转发的路径还是需要进行Indirect Tunnel Forwarding。源eNodeB还指明需要进行转发的EPS 承载，在哪里指明？ 3：源MME选定合适的目标MME，通过S10接口发送Forward Relocation Request消息给目标MME，包含如下一些主要内容： IMSI C The IMSI shall be included in the message except for the case: -????????? If the UE is emergency attached and the UE is UICCless. The IMSI shall be included in the message but not used as an identifier -????????? if UE is emergency attached but IMSI is not authenticated. ? Senders F-TEID for Control Plane M This IE specifies the address and the TEID for control plane message which is chosen by the source MME/SGSN. This information shall be used by the target MME/SGSN to the source MME/SGSN when sending Forward Relocation Response message, Forward Access Context Acknowledge message and Forward Relocation Complete Notification message. MME/SGSN UE EPS PDN Connections M Several IEs with this type and instance values shall be included as necessary to represent a list of PDN Connections SGW S11/S4 IP Address and TEID for Control Plane M 主要应用于SGW不需要Relocation的情形？ SGW node name C This IE shall be included if the source MME or SGSN has the source SGW FQDN. MME/SGSN UE MM Context M ? ? 4：目标MME选定相应的目标SGW，发送Create Session Request消息给目标SGW，消息中包含每个承载的上下文（针对基于GTP的S5/S8而言，包括PGW的地址和上行GTP－U在PGW侧的TEID值）。目标SGW为数据承载分配上行GTP－U的地址和TEID值，返回Create Session Response消息给源MME。没有分配转发数据的TEID吗？ 5：目标MME发送Handover Request消息给目标eNodeB，其中包括要建立的EPS承载的列表等内