Buck-Boost教育训练.pptVIP

Boost Converter  Buck Converter Reporter: Jack Date: 2009. 7 Switched-Mode Power Supply Buck Converter - Layout Separate analog ground and power ground. Only tie them at a single point to minimize grounding noise. Key Point : Always use ground plane to prevent noise coupling . Buck Converter - Layout Use wide and short traces for the main current paths. Input Loop ( high side mosfet on ) Output Loop ( low side mosfet on ) Buck Converter - Layout The feedback network : Resistors RFB1 andRFB2, should be kept close to the FB pin , and away f