复合工艺对轻质木塑复合材料性能的影响毕业设计.doc

论文题目：学 院： 材料工程学院 专业年级： 科学与工程20级 学 号： 姓　　名： 指导教师、职称： 教授 20xx年月日nfluence of compound technology on Properties of light weight Wood-Plastic Composites materials College： Material Engineering College Specialty and Grade： Materials Science and Engineering，20xx Number： 　　 Name： 　 Advisor： professor xxx Submitted time: xxxx，20xx 目 录 摘 要 1 关键词 1 Abstract 2 Key words 2 1 引言 3 1.1国内外研究现状 3 1.2 研究内容及意义 4 2 试验原料与试验方法 4 2.1 试验原料 4 2.1.1 材料 4 2.1.2 仪器 4 2.2 试验方法 5 2.2.1确定复合工艺因子因子： 5 2.2.2试验方案设计 6 2.2.3具体实验步骤 6 3 结果与讨论 10 3.1试验结果 10 3.1.1复合工艺对内结合强度的影响分析 10 3.1.2复合工艺的含水率的影响分析 11 3.1.3复合工艺对吸水厚度膨胀率的影响分析 12 3.1.4复合工艺对静曲强度的影响分析 13 4 结论 14 4．1 结论 14 4.2 存在的问题与建议 14 参考文献 16 致谢 17 摘 要：：；；Abstract: The influence of the process factors on the physical properties of wood-plastic composites was investigated. Polystyrene and Xylem fiber were used as the main raw material , and the various process factors such as different kinds of plastics , the mixing ratio between the wood material and its plastic counter part and hot pressing temperature，were examined. The results show that When the temperature is 140 ℃, hot pressing time was 7min, WPC mass ratio of 0.3, made the best performance of composite panels . At extremely high temperature the wood fiber material degrades drastically and plastic melting. The mixing ratio between wood and plastics has its best performance at ten to one wood-plastics ratio. Internal bond strength decrease and high water expansion when the woodplastic ratio is lower and properties of MOR are weakened when it becomes higher. Based on both of the maximum difference analysis ,the test shows the optimum conditions for wood- plastics composites to be a hot-pressing temperature of 190 ℃, a hot-pressing time of 7 min and a wood-plas