某高校kv降压变电所的电气设计论文资料.doc

毕 业 设 计（论 文） 题 目： 某高校10kv降压变电所的电气设计 （英文）： A university 10kv Substation Electrical Design 院 别： 自动化学院 专 业： 电气工程及其自动化 姓 名： 学 号： 指导教师： 日 期： 2010年3月 某高校10kv降压变电所的电气系统设计 摘要 本文设计任务旨在体现对本专业各科知识的掌握程度，同时检验本专业的学习结果。首先根据任务书上，通过对拟建变电站的概括以及出线方向来考虑，并通过对负荷资料的分析，安全，经济及可靠性方面考虑，确定了10kV以及站用电的主接线，然后又通过负荷计算及供电范围确定了主变压器台数，容量及型号，同时也确定了站用变压器的容量及型号，，最大持续工作电流及短路计算的计算结果，对高压熔断器，隔离开关，母线，绝缘子和穿墙套管，电压互感器，电流互感器进行了选型，从而完成了10kV电气一次部分的设计根据最大持续工作电流及短路计算的计算结果，，从而完成了10kV电气次部分的设计A university 10kv Substation Electrical Design ABSTRACT This design task is to reflect on the subjects of the professional knowledge levels, and test results of this professional learning. As the title of this paper is intended, not the transformation of the actual project, so this paper some of the views are not necessarily the actual situation for our school district. First of all, according to mandate of the book, so that the sum of the proposed substation and the outlet direction to consider, and through the analysis of load data, security, economic and reliability considerations, identified the main 10kV and electricity connection points, and then Load Calculation and supply area through the main transformer station to determine the number, capacity and model, but also to determine the capacity of the station, transformers and model, then, the maximum continuous operating current and short circuit calculation results, on the high-voltage fuse, isolating switch, bus, insulators and wall bushings, voltage transformers, current transformers for the selection, thus completing the first part of the 10kV electrical design. Finally, the maximum continuous operating current and short circuit calculation results, make line protection, transformer protection, bus protection, lightning protection. Thus completing the second part of the 10kV el