旅行箱拖手塑料套及注射模具机械CAD图纸设计.doc

编号： 　毕业设计(论文)说明书 题 目： 旅行箱拖手塑料套 及注射模具设计 院 （系）： 专 业： 学生姓名： 学 号： 指导教师位： 姓 名： 职 称： Abstract About mold development trend, I think it depends mainly on two aspects, that is, on the one hand is development trend of the mold service for all walks of life, on the other hand, the whole society and the world trend of the development of science and technology, it is actually need and possible. Molds for the parts, that is, forming products and services, so the mold must to stamping forming products () for their own development trend, the development trend of die must meet their requirements. Development trend of the main parts is light and elegant, fast and efficient production, low cost and high quality, each announced a mold development trend. The thesis gives a detailed introduction the process of an injection mold’s design, which is from product design to the whole plastic injection mold. This is a design for a plastic injection mold whose length is 140mm, 20mm in width, 20mm in height. The form design for a plastic sleeve has skidproof textures. Its broadside has screw eyes . The function of the hole is used to fix plastic sleeve on the telescoping shoring column. According to the design, its screw eyes are required to use a side core-pulling mechanism to do side core-pulling. After that, the knockout pin pushes out a fabricated part. This paper introduces the design standards of a drag hand plastic’s form, structure, etc, the process analysis of a fabricated part’s quality, volume calculation,materials, the confirm of production lot, the choice of molding methods and the choice of mold equipment, the injection’s structural design, the relative calculation in designing a mold, a mold’s mechanism design, the choice and check of an injection machine, relative calculation and check about molded parts. Meanwhile, it explains the working processes. Plenty of calculatio