轴承内外圈加工专用机床纵向机构机械CAD图纸设计.doc

摘 要 随着轴承工业的迅速发展，对轴承的加工精度、效率、可靠性提出了更高的要求。尺寸精度是轴承加工中的一项关键因素，而车床的进给机构直接影响轴承套圈加工的尺寸精度。因此，随着对轴承质量要求的不断提高，需要更加精密高效的车床进给机构。 本文是根据轴承厂轴承内外圈加工生产线项目的改造要求设计的，针对人工控制机床的进给加工，加工 论文根据轴承内外圈加工设备加工时进给的特点，对其纵向进给机构进行合理的设计。设计出利用液压驱动，前后调节机构调节进给量纵向进给机构。对驱动系统导向机构、前调节机构、后调节机构进行设计，确定具体。UG运动仿真界面进行运动仿真，分析仿真结果，得出相应结论。最后对纵向进给系统进行优化设计，提高其稳定性、可靠性。使其能满足轴承厂生产线繁重的工作。 关键词：进给机构；UG；虚拟装配；运动仿真 Abstract With the rapid development of bearing industry, the working accuracy, efficiency and reliability of bearing have been put forward higher requirements.A essential factor of bearing process is the dimensional accuracy, however, the feeding system of machine tools directly affects the dimensional precision of bearing ring process. Therefore, with the constant improvement of bearings quality requirements, it is necessary for the feeding system of machine tools to become more precise and efficient. This paper is based on the requirements of bearing inner and outer ring process production line project in bearing factory. As the process efficiency is low by the manual control of the machine feed process and the precision of the parts production is difficult to control. This paper designs a lathe of semi-automatic feed mechanism to instead of manual operation of conventional machines, in order to improve production efficiency and the part accuracy. This paper has a reasonable design of vertical feed mechanism what is based on the characteristic of feed processing by bearing inner and outer rings process equipment. The aim of this paper is designing a longitudinal feed mechanism through using hydraulic drive, before and after the vertical regulating mechanism adjust the feed. The paper devises a process equipment what is using hydraulic drive and before and after the adjustment mechanism to adjust the feed rate and after that identifies a specific size. This paper uses UG software for proceeding 3D modeling of longitudinal feed mechanism and virtual assembly, after that carries out on the