508050毕业设计终稿张海强研讨.docxVIP

华侨大学厦门工学院毕业设计 PAGE \* MERGEFORMAT48 页眉页脚无空行 摘要 语言重复，适当精简 设计是根据设计任务书的要求和《公路桥规》的规定对预应力混凝土连续梁桥整体现浇预应力混凝土连续梁桥进行方案设计。根据设计任务书要求和设计规范的规定，毕业设计主要是关于中小跨度预应力混凝土连续梁桥上部结构的设计。 本预应力混凝土连续梁桥共分为三跨（50m+80m+50m），分具体梁高分布 离式双向两车道，设计荷载为公路-Ⅰ级，主梁采用单箱单室预应力混凝土箱规范需说明版本 梁，梁高为2m-4.4m，截面采用变截面形式，桥面净宽为8.5m。依据《公路桥涵设计通用规范》及《公路钢筋混凝土及预应力混凝土桥涵设计规范》计算结构各种作用效应以及荷载组合效应，还运用了桥梁设计软件Midas，并对桥梁恒载、活载及内力进行分析计算。根据所得结果用按《桥规》规定，预应力梁应满足使用极限状态下的应力要求和承载极限状态下的强度要求。然后依据《通规》及《公预规》的具体规定进行验算，包括配束后的荷载组合效应计算、截面强度验算、抗裂验算和应力验算，结果表明结构满足强度要求。 关键词：预应力混凝土、连续箱梁、Midas Abstract 对照中文进行修改 The design is in accordance with the provisions of the requirements of the design task and highway bridge rules for prestressed concrete continuous girder bridge cast-in-place prestressed concrete continuous beam bridge scheme design According to the design requirements and design requirements and design specifications, the graduation design is mainly about the design of the upper structure of the medium and small span prestressed concrete continuous girder bridge. The prestressed concrete continuous girder bridge is divided, separating type two-way two lane is a three span 50m+80m+50m, design load for highway - grade I, girder with single box single room prestressed concrete box beam, the beam high for 2m-4.4m, section with variable cross-section, bridge deck width 8.5m. On the basis of the design of highway bridges and culverts general norms and the highway reinforced concrete and prestressed concrete bridges and culverts code for design of calculating various structural effect and load effect combination, and using the bridge design software MIDAS, and the bridge dead load, live load and internal force calculation and analysis. According to the results obtained by the bridge gauge, the prestressed beams should meet the stress requirements and the strength requirements of the load limit state under the ultimate state.. Then according to the general regulation and public pre regulation the specific provisions of the check, including tendons afte