986 检验指导书 (001-010).docVIP

Standard Inspection ProcedureNO.QE-986-001ItemsInspection ItemsJudge standard Gauge or EquipmentVersion試用版Part/No21-986001Description986底部支撐架DCNA B 尺 寸 外 觀a. 9.52±0.13mm(含一個料厚) b. 12.70±0.13mm(含一個料厚) c. 90°±30’ 產品外表面不可有變形,氧化; 2.各切料口不可有銳利,毛刺、鋅絲現象. 此標準未另行規定部分依據東驊公司品質標準指導準則. 備注:材質為SGCC Ｔ＝1.20mm.游標卡尺 游標卡尺 角度規 Illustration: Modification descriptionVersionApproved ByChecked ByPrepared By趙緒文 2007.09.04Remarks1. Appearance should be inspected comparing with sample, for other mechanical, electronic character etc, should be inspected reference to drawing. When it is difficult to judge, it should be submitted to supervisor for solution.Our Quality Policy :『Customer First ,Continuous Innovation』 Page 1 of 1 Standard Inspection ProcedureNO.QE-986-002ItemsInspection ItemsJudge standard Gauge or EquipmentVersionRev01Part/No21-986000Description986I/O板DCNA B C 尺 寸 鉚 柱 外 觀a. 11.67±0.13mm(含一個料厚) b.11.32±0.13mm(含一個料厚) c. 90°±30’ 14-560362 986鉚柱4-40*6.35 1pcs 推力≧15kgf 1.產品外表面不可有油污,變形,氧化; 2.不可有銳利之刀口,毛刺、鋅絲. 此標準未另行規定部分依據Newsis公司品質標準指導準則. 等级面：B级面 備注:材質為SGCC Ｔ＝0.80mm.游標卡尺 游標卡尺 角度規 推力計 Illustration: Modification descriptionVersion取消尺寸d管控項01Approved ByChecked ByPrepared By趙緒文 2007.10.24Remarks1. Appearance should be inspected comparing with sample, for other mechanical, electronic character etc, should be inspected reference to drawing. When it is difficult to judge, it should be submitted to supervisor for solution.Our Quality Policy :『Customer First ,Continuous Innovation』 Page 1 of 1 Standard Inspection ProcedureNO.QE-986-003ItemsInspection ItemsJudge standard Gauge or EquipmentVersion試用版Part/No41-986000Description986IO包裝箱DCNA B C尺 寸 外 觀 實 裝a.533+/-3mm b.376+/-2mm c.208+/-2mm d.28±1mm(不含料厚) e.5