基于51单片机函数号发生器设计论文论文.docVIP

PAGE  PAGE 19 摘 要: 本系统利用单片机STC89C51RC采用程序设计方法产生正弦波、三角波、矩形波三种波形，再通过D/A转换器DAC0832将数字信号转换成模拟信号，滤波放大，最终由示波器显示出来，能产0Hz—535Hz的波形。通过按键来控制三种波形的类型选择、频率变化，并通过液晶屏1602显示其各自的类型以及数值，系统大致包括信号发生部分、数/模转换部分以及液晶显示部分三部分，其中尤其对数/模转换部分和波形产生和变化部分进行详细论述。 关键词：单片机STC89C51RC、DAC0832、液晶1602 Abstract: this system capitalize on STC89C52RC，it makes use of central processor to generate three kinds of waves, they are triangle wave, and use D/A conversion module, wave generate module and liquid crystal display of 1602, it can have the 0Hz-535Hz profile. In this system it can control wave form choosing, frequency, range,can have the sine wave, the square-wave, the triangular wave. Simultaneously may also take the frequency measurement frequency,and displays them through liquid crystal display of 1602. this design includes three modules. They are D/A conversion module, wave generate module and liquid crystal display of LED module. In this design, the wave generator into wave form module and D/A conversion module are discussed in detail. key word: STC89C51RC, DAC0832, liquid crystal 1602. ?  目录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc328384341 1.系统设计  PAGEREF _Toc328384341 \h 2  HYPERLINK \l _Toc328384342 1.1、设计要求  PAGEREF _Toc328384342 \h 2  HYPERLINK \l _Toc328384343 1.2方案设计与论证  PAGEREF _Toc328384343 \h 2  HYPERLINK \l _Toc328384344 1.2.1 信号发生电路方案论证  PAGEREF _Toc328384344 \h 2  HYPERLINK \l _Toc328384345 1.2.2 单片机的选择论证 …. PAGEREF _Toc328384345 \h 3  HYPERLINK \l _Toc328384346 1.2.3 显示方案论证  PAGEREF _Toc328384346 \h 3  HYPERLINK \l _Toc328384347 1.2.4键盘方案论证  PAGEREF _Toc328384347 \h 3  HYPERLINK \l _Toc328384348 1.3总体系统设计  PAGEREF _Toc328384348 \h 4  HYPERLINK \l _Toc328384349 1.4硬件实现及单元电路设计  PAGEREF _Toc328384349 \h 4  HYPERLINK \l _Toc328384350 1.4.1单片机最小系统的设计  PAGEREF _Toc328384350 \h 4  HYPERLINK \l _Toc328384351 1.4.2 波形产生模块设计  PAGEREF _Toc328384351 \h 5  HYPERLINK \l _Toc328384352 1.4.3 显示模块的设计  PAGEREF